Microcircuitos bet on clean energy

We have been in the market for more than 30 years, positioning ourselves as one of the largest manufacturers and suppliers of printed circuits, but now we bet on photovoltaic solar energy. We produce electricity from renewable sources obtained mainly through solar radiation, allowing the generation of energy on a large scale with the use of 102 solar panels of 325kwp and an inverter on grid, located on the roof of our headquarters, which mean for the company a annual energy saving of 1,295.64 kwh / kwp, represented by a coefficient of 83.1%. The company seeks to reduce the current consumption of the network, also achieving greater energy efficiency.

According to the installed power, environmental factors can be determined provided by accredited institutions worldwide.

According to equivalent data based on Rocky Mountain Institute calculations, the following environmental equivalents can be determined:

Thanks to the use of renewable energy

In microcircuits we do not generate constant chemical waste, thanks to the processes we know to separate the solid particles from the chemicals and with it we only have to regenerate and we can use the solution again.

You can determine that the useful life of greenhouse gases that would have been generated if you had used clean energy. The quantities recorded are based on the averages by state of the Department of Energy (DOE) of the USA, or averages by country of the International Energy Agency (IEA) calculated from the kilowatt hours generated during the useful life of the system . If the monitoring of the system is a later adaptation, there is a possibility that all energy production is not taken into account.